Troubleshoot bosch dishwasher e19 error like a pro: reset guide included

Are you facing the dreaded E19 error code on your Bosch dishwasher? This frustrating issue can leave you with a pile of dirty dishes and a sense of helplessness. Don’t worry; this comprehensive guide will provide you with step-by-step instructions on how to reset your dishwasher and eliminate the E19 error code.

What is the E19 Error Code?

The E19 error code indicates a problem with the dishwasher’s water supply. It can be caused by various factors, including:

• Low water pressure
• Clogged water inlet valve
• Defective water sensor
• Faulty control board

Troubleshooting the E19 Error Code

Before attempting to reset your dishwasher, it’s important to troubleshoot the underlying cause of the E19 error code. Here are some steps to follow:

1. Check Water Pressure: Ensure that your dishwasher has adequate water pressure. The recommended pressure range is between 20 and 120 psi.

2. Inspect Water Inlet Valve: The water inlet valve is located behind the dishwasher. Disconnect the water supply and check for any debris or blockages. Clean or replace the valve if necessary.

3. Test Water Sensor: The water sensor monitors the water level in the dishwasher. If it’s faulty, the dishwasher may not fill properly. Use a multimeter to test the sensor and replace it if it’s not functioning correctly.

4. Examine Control Board: The control board is responsible for controlling the dishwasher’s functions. If it’s damaged or malfunctioning, it can cause the E19 error code. Contact a qualified technician to inspect and repair the control board.

How to Reset Bosch Dishwasher E19

Once you’ve identified and addressed the underlying cause of the E19 error code, you can proceed with resetting your dishwasher:

1. Unplug the Dishwasher: Disconnect the dishwasher from the power outlet.

2. Wait 30 Seconds: Allow the dishwasher to sit unplugged for at least 30 seconds. This will discharge any residual power.

3. Reconnect the Dishwasher: Plug the dishwasher back into the power outlet.

4. Press and Hold Start Button: Locate the start button on the dishwasher’s control panel. Press and hold it for 5 seconds.

5. Release and Press Again: Release the start button and press it again immediately.

6. Wait for Reset: The dishwasher will enter reset mode and display “0:00” on the display.

7. Run a Test Cycle: Once the reset is complete, run a short test cycle to ensure that the dishwasher is functioning properly.

Additional Tips for Troubleshooting the E19 Error Code

• Clean the Drain Hose: A clogged drain hose can prevent the dishwasher from draining properly, leading to the E19 error code. Disconnect the drain hose and inspect it for any obstructions.

• Inspect the Door Latch: The door latch must be properly closed for the dishwasher to operate correctly. Check the latch for damage or misalignment.

• Check the Float Switch: The float switch detects the water level in the dishwasher. If it’s stuck or damaged, it can cause the E19 error code. Remove the float switch and clean or replace it if necessary.

What You Need to Know

1. Why does my Bosch dishwasher keep showing the E19 error code?

The E19 error code can be caused by various factors, including low water pressure, clogged water inlet valve, faulty water sensor, or a damaged control board.

2. How long should I wait before unplugging my dishwasher to reset it?

Allow the dishwasher to sit unplugged for at least 30 seconds before plugging it back in to discharge any residual power.

3. What should I do if the E19 error code reappears after resetting my dishwasher?

If the E19 error code persists after resetting your dishwasher, it may indicate a more serious issue that requires attention from a qualified technician.