Troubleshooting your kenmore dryer? here’s how to fix a faulty gas valve coil

If your Kenmore dryer is experiencing issues with heating or igniting the flame, it’s possible that the gas valve coils need to be replaced. Replacing these coils is a relatively straightforward task that can be completed in a few simple steps. In this comprehensive guide, we’ll provide you with detailed instructions on how to replace gas valve coils on Kenmore dryers.

Safety Precautions

Before beginning any repairs, it’s essential to take the following safety precautions:

• Unplug the dryer from the power outlet.
• Turn off the gas supply to the dryer.
• Allow the dryer to cool completely.

Tools and Materials Required

• Phillips head screwdriver
• Flathead screwdriver
• Needle-nose pliers
• New gas valve coils (compatible with your Kenmore dryer model)

Step-by-Step Instructions

1. Remove the Front Panel

• Open the dryer door and locate the two screws at the top of the front panel.
• Remove the screws using a Phillips head screwdriver.
• Carefully lift the front panel off the dryer and set it aside.

2. Locate the Gas Valve

• Once the front panel is removed, you’ll see the gas valve located at the bottom of the dryer.

3. Disconnect the Electrical Wires

• Using a flathead screwdriver, gently pry the electrical wires loose from the gas valve coils.
• Note the position of each wire before disconnecting them, as they will need to be reconnected in the same order.

4. Remove the Old Coils

• Use a pair of needle-nose pliers to gently squeeze the plastic tabs holding the coils in place.
• Carefully pull the old coils straight out of the gas valve.

5. Install the New Coils

• Insert the new coils into the gas valve, ensuring that they are properly aligned.
• Push the plastic tabs back into place to secure the coils.

6. Reconnect the Electrical Wires

• Reconnect the electrical wires to the gas valve coils in the same order as they were disconnected.

7. Reassemble the Dryer

• Reinstall the front panel on the dryer and tighten the screws.
• Turn on the gas supply to the dryer and reconnect it to the power outlet.

Troubleshooting

If the dryer is still not heating or igniting after replacing the gas valve coils, check the following:

• Electrical connections: Ensure that all electrical wires are securely connected to the gas valve coils.
• Gas supply: Verify that the gas supply is turned on and that there are no leaks.
• Igniter: Check the igniter to make sure it is functioning properly.

Tips

• Before replacing the gas valve coils, clean the terminals on the coils and the gas valve with a wire brush.
• It’s recommended to replace both coils at the same time, even if only one is faulty.
• If you’re not comfortable replacing the gas valve coils yourself, contact a qualified appliance repair technician.

What People Want to Know

1. What are the symptoms of faulty gas valve coils?

• Dryer not heating or igniting
• Flame flickering or unstable
• Excessive gas odor

2. How often should I replace gas valve coils?

• Gas valve coils typically last for several years, but it’s a good idea to inspect them annually and replace them if they show signs of wear or damage.

3. Can I use gas valve coils from a different brand of dryer?

• No, it’s important to use gas valve coils that are specifically designed for your Kenmore dryer model. Using coils from a different brand or model could create safety hazards.