Warming tips for cozy home heating
Guide

Step-by-step guide: how to remove astra h heater blower and fix the chilly

Rob is a seasoned home improvement writer with over 15 years of experience researching and recommending products for the home. Prior to starting Nurturing Homeaid, he wrote extensively for This Old House magazine and has been featured as a home expert on several TV and radio programs. An avid DIY-er,...

What To Know

  • Replacing a faulty heater blower in your Astra H is a common repair task that can be completed at home with the right tools and knowledge.
  • With the blower motor detached, you can now remove the heater blower from the housing.
  • Replacing a heater blower in your Astra H is a straightforward task that can be completed in under an hour.

Replacing a faulty heater blower in your Astra H is a common repair task that can be completed at home with the right tools and knowledge. This comprehensive guide will provide you with step-by-step instructions on how to remove the heater blower so that you can replace it and restore warmth to your cabin.

Safety Precautions

Before you begin, ensure your safety by following these precautions:

  • Park your Astra H on a level surface and engage the parking brake.
  • Allow the engine to cool down to avoid burns.
  • Disconnect the negative terminal of the battery to prevent electrical shock.

Tools and Materials Required

  • 10mm socket wrench
  • Phillips screwdriver
  • Torx T20 screwdriver
  • Replacement heater blower

Step-by-Step Removal Process

1. Remove the Glove Box

  • Open the glove box and detach the two clips on the sides.
  • Pull the glove box straight out to remove it.

2. Disconnect the Battery Terminal

  • Locate the negative terminal of the battery and loosen the nut using a 10mm socket wrench.
  • Disconnect the terminal and move it aside.

3. Remove the Cowl Panel

  • Locate the cowl panel at the base of the windshield.
  • Remove the four screws securing the cowl panel using a Phillips screwdriver.
  • Lift the cowl panel away from the vehicle.

4. Disconnect the Heater Blower Harness

  • Locate the electrical harness connected to the heater blower.
  • Press the release tab on the harness connector and pull it apart.

5. Remove the Blower Motor Screws

  • Locate the three screws securing the blower motor to the housing.
  • Remove the screws using a Torx T20 screwdriver.

6. Detach the Blower Motor

  • Carefully lift the blower motor out of the housing.
  • Disconnect the air duct from the blower motor by squeezing the clips and pulling it off.

7. Remove the Heater Blower

  • With the blower motor detached, you can now remove the heater blower from the housing.
  • Grip the heater blower and pull it straight out.

Installation of New Heater Blower

Once the old heater blower is removed, you can install the new one by reversing the removal steps:

1. Insert the new heater blower into the housing.
2. Connect the air duct to the blower motor.
3. Secure the blower motor to the housing using the three screws.
4. Reconnect the electrical harness to the blower motor.
5. Reinstall the cowl panel and secure it with the screws.
6. Reconnect the negative terminal of the battery.
7. Reinstall the glove box.

Testing the New Heater Blower

After installation, start the engine and turn on the heater blower. Check if the air is flowing properly and that there are no unusual noises. If everything works correctly, your heater blower replacement is complete.

Tips for Success

  • Use a flashlight to illuminate dark areas and make it easier to see what you’re doing.
  • If you encounter any resistance when removing the screws, use a penetrating lubricant to loosen them.
  • Be careful not to damage any electrical wires or components.
  • If you have any doubts or difficulties, consult a qualified mechanic.

Troubleshooting

If you experience any issues after replacing the heater blower, here are some troubleshooting tips:

  • Check the electrical connections to ensure they are secure.
  • Inspect the air duct for any blockages or damage.
  • Verify that the blower motor is correctly seated in the housing.
  • If the blower motor is not spinning, it may be faulty and need to be replaced.

Final Thoughts

Replacing a heater blower in your Astra H is a straightforward task that can be completed in under an hour. By following the steps outlined in this guide, you can save money on labor costs and restore warmth to your cabin during cold weather.

Frequently Asked Questions

Q: How often should I replace the heater blower?

A: Heater blowers typically last for several years, but they may need to be replaced more frequently if they are used extensively.

Q: Can I clean the heater blower instead of replacing it?

A: In some cases, it is possible to clean the heater blower to improve its performance. However, if the blower is damaged or worn out, it should be replaced.

Q: How do I know if my heater blower is faulty?

A: Signs of a faulty heater blower include weak airflow, unusual noises, or complete failure to operate.

Rob Sanders

Rob is a seasoned home improvement writer with over 15 years of experience researching and recommending products for the home. Prior to starting Nurturing Homeaid, he wrote extensively for This Old House magazine and has been featured as a home expert on several TV and radio programs. An avid DIY-er, Rob takes pride in testing out the latest tools and gadgets to see how they can make home projects easier. When it comes to heating systems, he's evaluated over 50 different furnace and boiler models over the years. Rob founded Nurturing Homeaid with his business partner Jim in 2020 to provide homeowners with genuine product recommendations they can trust. In his free time, Rob enjoys remodeling old homes with his family and traveling to visit architectural landmarks across the country. He holds a bachelor's degree in Journalism from Syracuse University.
Back to top button