Samsung dishwasher warning: over level water error? here’s the ultimate solution
What To Know
- If the float switch is faulty or stuck, it may send an incorrect signal to the control board, causing the dishwasher to overfill.
- If the control board is faulty, it may not be able to properly manage the water level, resulting in the over level water error.
- The error could be caused by a clogged drain hose, a faulty float switch or water level sensor, or a malfunctioning control board.
Are you facing the dreaded “Over Level Water” error on your Samsung dishwasher? Don’t panic! This common issue can be easily resolved with a few simple troubleshooting steps. Follow our comprehensive guide to get your dishwasher back to its sparkling best.
1. Reset the Dishwasher
Sometimes, a simple reset can clear out any temporary glitches. Unplug the dishwasher from the power outlet for 10 minutes. Plug it back in and start a new cycle.
2. Check the Water Supply
Ensure that your dishwasher is receiving an adequate supply of water. Inspect the water inlet hose for any kinks or leaks. Also, check the water pressure by running the sink or bathtub. If the water pressure is low, it can prevent the dishwasher from filling properly.
3. Inspect the Drain Hose
A clogged drain hose can cause water to accumulate in the dishwasher and trigger the over level water error. Disconnect the drain hose from the sink and check for any blockages. If necessary, use a drain snake to clear the hose.
4. Verify the Float Switch
The float switch is a small device that detects the water level in the dishwasher. If the float switch is faulty or stuck, it may send an incorrect signal to the control board, causing the dishwasher to overfill. Locate the float switch in the base of the dishwasher and inspect it for any debris or damage.
5. Examine the Water Level Sensor
The water level sensor measures the water height in the dishwasher. A malfunctioning sensor can provide inaccurate readings, leading to the over level water error. Test the sensor by disconnecting it from the control board and measuring the resistance across its terminals. If the resistance is outside the specified range, replace the sensor.
6. Check the Control Board
The control board is the brain of the dishwasher and controls all its functions. If the control board is faulty, it may not be able to properly manage the water level, resulting in the over level water error. In this case, it’s best to contact a qualified appliance repair technician for assistance.
7. Clean the Dishwasher
Over time, food particles and detergent residue can accumulate in the dishwasher, leading to performance issues. Run a cleaning cycle with a dishwasher cleaning solution or vinegar to remove any buildup.
Troubleshooting Wrap-Up
By following these troubleshooting steps, you can effectively resolve the over level water error on your Samsung dishwasher. If the issue persists, don’t hesitate to contact a professional appliance repair technician for further assistance.
FAQ
Q: Why does my Samsung dishwasher keep showing the over level water error?
A: The error could be caused by a clogged drain hose, a faulty float switch or water level sensor, or a malfunctioning control board.
Q: How do I reset my Samsung dishwasher?
A: Unplug the dishwasher for 10 minutes, then plug it back in and start a new cycle.
Q: Can I replace the control board on my Samsung dishwasher myself?
A: Replacing the control board requires electrical knowledge and experience. It’s recommended to contact a qualified appliance repair technician for this task.